How To Repair A Push Pull Tub Stopper That Will Not Stay Closed

Download Article

Download Commodity

Chances are you don't spend much fourth dimension thinking about the little rod that opens and closes your drain — until information technology fails to work. Fortunately, there is no rocket science happening under your sink, but a couple of simple rods that claw together to push the stopper up and downwards. They're pretty easy to adjust if yous know what you're looking for.

Steps Download Article

1. i

   Sympathize a fleck of what's going on nether your sink. ^[1] When you pull upward on the drain rod (ane), it pulls up on another rod (3) that'southward nether your sink, behind the drain. This rod passes through a brawl articulation (5) and hooks into a notch (half dozen) in the bottom of your drain stopper (7).

   • Yous can move the rod from below the sink to see the mechanism operate, or inquire somebody to move the rod from to a higher place while you watch from below if you demand to learn which i it is.

2. 2

   Button and pull the rod. Notice whether the drain stopper moves. If it does, but it doesn't stay where you put information technology, tighten the nut. If the drain stopper doesn't move with the rod, or if the movement doesn't seem to exist related (yous pull the rod and the bleed stopper only wiggles), then something is probably disconnected.

   Advertizement

3. 3

   Adjust the nut. ^[ii] On the back of the drainpipe, at that place is a nut. It may have tabs for manus-tightening or it may require a wrench. The nut in this pic (shown at 4 in the diagram above) controls how stiff the mechanism is. If the stopper moves equally it should just doesn't stay put, all yous need to do is tighten the nut (turn it clockwise). If the action is besides stiff, loosen the nut a trivial. Check the activity and adjust until it feels about right.

4. 4

   Make sure the two rods are connected. ^[3] If the stopper isn't moving or isn't moving much, this is the first affair to bank check. There'south usually a simple spiral and nut connection at the joint. If it's missing or asunder, connect it. Call up that this joint needs to move, though, and so connect it loosely enough that the joint volition act every bit a hinge.

   • Utilize a clip such equally the one shown in the photograph to attach the two rods securely together while leaving them free to move.

5. five

   Attach the stopper to the lower rod. ^[four] Pull up on the stopper with your fingers. Information technology should not come out. If it does, or if information technology'southward non moving when the lower rod moves, yous'll need to attach it.

   • Accept a look at the stopper. Yous volition see something looking like a hook with a notch in the middle.
   • Look into the drain. You'll see the lower rod protruding from the dorsum of the bleed. Your object is to go the notch hooked onto the lower rod.
   • Hold the stopper so that the notch is at a correct bending to the lower rod. Notice which style you indicate the hook.
   • Lower the stopper into the drain. Push it in far enough that the lower part of the claw is just past the rod. Experience your mode to this point, and use the rod to motility the lower rod to assist yourself discover it.
   • Rotate the stopper 90 degrees so that the hook pops around the lower rod and the tip of the rod ends upwards in the notch. This maneuver may have a few tries, but don't surrender.

6. 6

   Adjust the location of the lower rod.' ^[five] If you lot accept trouble getting the hook over the rod so that it's in the notch, or if nothing you exercise seems to engage the stopper with the lower rod, the rod itself may exist in the wrong place. Remove the stopper and look in the drain. The rod should extend between half and iii-quarters of the way into the drain piping.

   • To adjust the distance the lower rod extends into the bleed pipe, loosen the nut. Push the rod in farther or advisedly pull it out a bit. Try non to pull it all the mode out. When it is where you desire it, tighten the nut downwardly again until the activeness is stiff plenty.

7. 7

   Adjust the travel of the lower rod. You lot may find that the lower rod goes too far up or downwards. Motion the prune at joint (2) up or downwards, in or out.

   • Alter how high up the lower rod attaches to the upper rod. You may run across a serial of holes on the upper rod. Movement the lower rod to a higher hole if you'd like the stopper to be lower downwards in the drain. Move the lower rod to a lower hole if yous'd like the stopper college up.
   • Modify how far back on the lower rod the upper rod is attached. This choice may not be built in, but you can brand the overall travel of the stopper greater by attaching the upper rod further away from the ball joint. Conversely, you lot can lessen the travel of the stopper by attaching the upper rod closer to the brawl joint.

   Advertizing

Ask a Question

200 characters left

Include your email address to go a message when this question is answered.

Submit

Advertisement

• Replace any parts of this machinery that are missing or damaged beyond serviceability. You'll find them at any hardware store, and they're not that costly.

• Clear the space under and effectually your sink if you observe you demand to work downward in that location. It's bad-mannered enough without working effectually all the clutter that accumulates nether sinks.

• Some newer pop-ups may seem to not agree the stopper closed, simply only require a quarter-plow of the rod in order to hold the stopper airtight.

• Pulling out the stopper tin can be messy. If it comes out with a mess of hair or other debris, remove this affair and employ a snake or other means to clear whatsoever that may be left backside in the bleed earlier reassembling.

• If yous can't prepare your bleed correct away, you lot may exist able to pull the stopper out temporarily or wedge something under it to hold it open up. Try the corner of a sponge. Don't apply an object that volition fit down the drain, though.

Thanks for submitting a tip for review!

Advertising

• Make sure not to hit your head on the cabinet as yous climb out from under the sink.

Advert

Nearly This Article

Cheers to all authors for creating a page that has been read 137,376 times.

Did this article help you?

Source: https://www.wikihow.com/Make-a-Pop-up-Drain-Stay-Closed

Posted by: gummstold1968.blogspot.com

Share this post